What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 21.06.2025 11:40
These devices are installed between the “hot” and “neutral” and protective ground.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Why does my crush make me jealous about having a girlfriend?
Upvotes:
I post the exact comment here.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Mountaineers Defeat Kentucky to Advance to Super Regionals - West Virginia University Athletics
This one hit behind the barn.
It seems Mohan does not understand the difference between a comment and an Answer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Sed autem voluptatibus minima impedit officia ipsa.
Now when you have a certain ac resistance, then a current flows in a loop.
He then asserts :
so, what happens?
How did my ex move on very fast?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
There are three different concepts here that are getting confused.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Lawyers could face ‘severe’ penalties for fake AI-generated citations, UK court warns - TechCrunch
but this device (an Inductor) … impedes the rapid changes in the current.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There are two important concepts here.
Why would my nipples hurt when I touch them?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
a photo is worth a thousand words.
Can you explain the meaning of "mint condition" in relation to antiques or collectibles?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Here is a simplified AC power diagram.
but I think this circuit , shows a few more pieces.
2024–10–16 [ OO OLAOYE OYEBODE ]
What's the biggest myth about illegal immigrants?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But it can get overloaded, and no longer works.
Will German support for Ukraine decrease after the early elections on February 23, 2025?
What does a fuse do?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
But… the neutral is now “floating” because of the 1 ohm resistance.
At one ohm, the resistor has a maximum of 1 watt power.
[image of Common-mode choke]
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
First Sentence:
Because the load is inductive, the current lags the voltage.(by a bit).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The other is “what does a “fuse” do?”
These are simplified answers to the original question, and does not change anything I wrote above.
The bolt then partially travels down the line to your home.
A fuse is a non-resetable over current circuit protector.
For this case there are devices called Metal oxide varistors (MOV).
(Dc diagram shown, AC is similar).
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
nine
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The third is lightning and “how it gets conducted into a home.”
Barnstars:
A circuit breaker is similar, but is resettable.
eight
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This device then solves the entire problem.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
An AC voltage/ current source, and an ac inductive load.
What is lightning?
what exactly is a ‘surge’ protector?
In schematic diagrams this is the symbol for a fuse:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
One is “what exactly is in a ‘surge protector’ ? ”
It also is a device that limits the change in current flow.
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes the function of a fuse.
the problem then depends on "how fast does the fuse operate?".
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is 'the assistant's answer'
[old diagram got deleted by accident]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–10[John johnson John Johnson ]
Edit 2024–10.
At least they know the answer if they wanted it.
This is where the MOV conducts again, and dissipated the energy.
One
He then describes Rainy Season and Lightning.